9
Repair Instructions - GP8035 Pump
11) Remove the connecting rod
screws (24).
Connecting rods are
marked 1 to 3 for identifi cation. Do
not twist connecting rod halves or in-
terchange them. When reassembling,
the connecting rod must be fi tted in
their exact original position on the
crankshaft journals.
12) Push connecting rod halves together
with the crosshead as far as possible into
the crosshead guide. Take out bearing cover
(14/14A) and push out crankshaft taking par-
ticular care that the con rod doesn’t get bent.
Check surfaces on the connecting rods (24),
crankshaft (22) and crossheads (25). Check
the surfaces of the crosshead guides in the
crankcase for any unevenness.
13) Reassemble in reverse order.
Thread the long end of the crankshaft
together with the inner bearing rings into
the crankcase; then mount outer bearing
ring (20) and spacer ring (22A).
Mount
connecting rod halves in their exact
original position and tighten at 37 Ft-lbs.
Connecting rods must be able
to move slightly sideways on the stroke
journals.
To Dismantle Crankcase Gear
10)
Take out plungers and seal sleeves as
described above. Drain the oil by taking off
the plug (12). After removing the clip ring
(33B), lever out the seal retainer (33) with a
screwdriver. Open hose adapter (K11) and
remove gear cover (K3).
Remove the cooling
vane plate (K1) by removing the screws (K4)
