aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer
un fonctionnement indésirable de l'appareil.
IC Radiation Exposure Statement
The modular can be installed or integrated in mobile or fix devices only. This modular cannot be
installed in any portable device .
This modular complies with IC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This modular must be installed and operated with a minimum distance of
20 cm between the radiator and user body. Cette modulaire doit être installé et utilisé à une
distance minimum de 20 cm entre le radiateur et le corps de l'utilisateur.
If the IC number is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following:
“Contains
IC:
6132C-BP1064L2
”
when the module is installed inside another device, the user manual of this device must contain
below warning statements;
1. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science
and Economic Development Canada’s licence
-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
2. Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS)
d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis
aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de
provoquer un fonctionnement indésirable de l'appareil.
The devices must be installed and used in strict accordance with the manufacturer's instructions
as described in the user documentation that comes with the product
This device has been designed to operate with the antenna listed below, and having a peak gain
of 2.81dBi @ 2.4GHz,, Antennas not of the same type and having a higher gain specified above
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Model: BP10xx_F
