GHM Delta OHM HD2304.0, Руководство по эксплуатации

Страница: 13 / 28

HD2304
- 13 -
V1.8
4. unscrew t he ring on t he opposit e side as illust rat ed in t he figure:
5. open t he t wo m odule shells: t he pr int ed circuit t o which t he probe m ust be
connect ed is housed inside. On t he left t here are t he 1…4 point s on which t he
sensor wires m ust be welded. The JP1…JP4 j um pers are in t he cent er of t he board.
These m ust be closed wit h a t in bead for som e t ype of sensors:
1
2
3
4
Pt100 3 fili
Pt1000
Ni1000
Not Used
Ca u t ion ! Before welding, pass t he probe cable t hrough t he fair lead and gasket .
6. Weld t he w ires as shown in t he t able:
Se n sor Boa r d conn e ct ion Ju m pe r t o close
Pt 100 4
wires
4
JP4
3
JP3
1
JP1
2 JP2
Pt100
4 wires
None
Ensure t he welds are clean and perfect .
7. Once t he welding operat ion is com plet e, close t he t wo shells;
8. insert t he gasket in t he m odule;
9. screw t he fair lead and t he ring.
10. At t he ot her end of t he m odule, ent er t he ring w it h t he O- Ring as indicat ed in t he
pict ure
11.Make sure t he cable is not t w ist ed while you are screwing t he fair lead. Now t he
probe is ready.