Gfp 44TH
October 2017
20
18c Mounting print to a pre-coated mounting board
1.
Pull back and fold down 1” of the liner from the pre-coated mounting board
2.
Adhere leading edge of the print to the exposed adhesive on the board
3.
Insert leading 1” of the board into the nip rollers
4.
Adjust the roller pressure to the preset gap setting on the pressure handle
5.
Lay print over top nip roller
6.
Hold release liner on board with one hand and apply pressure to print as it comes
over the top roller.
7.
Depress the foot switch to run the board and print through the rollers
19. Heat Sensor Blocked Function
1.
If the heat sensor becomes blocked or has failed the power indicator will flicker. After
one minute, the machine will automatically turn off its heating system. It is necessary
to turn off the machine at once and check to see what is blocking the sensor. If the fault
is not eliminated, please contact with the after-sales service personnel.
2.
During normal operation of the machine, the buzzer gives two sounds and the power
indicator flickers. In this case, it shows that temperature detected by the temperature
sensor on the upper roller is more than 180
℃
and the machine will automatically turn
off its heating system.
3.
If the machine is under high temperature status and there is any paper blocking
temperature sensor, the machine will warn and turn off the heating system, and the
power indicator will flicker and buzzer gives three sounds circularly. According to
different sounds of the buzzer, you can judge fault type of the machine.
20. Roller Cleaning Function
1.
First, remove the Safety Shield and Feed Table
2.
Turn main power ON/OFF switch to OFF position
3.
Press and hold the Reverse switch while turning the ON/OFF switch back to ON
4.
Release the Reverse switch
a.
You will hear two audible beeps and the Power and Ready lights will
alternate on and off indicating the Cleaning mode
5.
Use the reverse switch to rotate the rollers for cleaning
6.
To return to normal operation, turn the main ON/OFF switch to OFF
7.
Return Safety Shield and Feed Table to the home position
