+GF+ MSA 2 MULTI, Инструкция по эксплуатации

Страница: 24 / 64

Error messages Operating Instructions MSA 2 MULTI
22
5 Error messages
In case of anomalies or errors, the MSA 2 MULTI pops up a
specific message useful to identify the possible issue. The
related number will be even tracked within the welding protocol,
to give evidence of the accident.
The error message appears on the display with the following
format:
E-1
Vi

The table below summarizes all the messages managed by the
electro-fusion unit, with a brief explanation of the possible
causes.
ERR DISPLAY
INDICATION MEANING COMMENT
E1
Vi

MAINS VOLTAGE TOO LOW Generator voltage/freq. below the threshold
E2 Vi

MAINS VOLTAGE TOO HIGH
Generator voltage/freq. above the threshold
E3 Vi
OUTAGE DURING LAST FUSION
Power cord disconnected during last fusion
E4


FUSION INTERRUPTED WITH
STOP BUTTON
Fusion stopped by the user
E5

-


AMBIENT TEMP. TOO LOW
Temp. sensor detected a value below the
threshold
E6


AMBIENT TEMP. TOO HIGH
Temp. sensor detected a value above the
threshold
E7

i

INTERNAL TEMP. TOO LOW
EF unit cannot fuse, since it is too cold
E8

i

INTERNAL TEMP. TOO HIGH
EF needs to cool down, since it is too hot
E9

FITTING RESISTANCE TOO LOW
Fitting faulty
E10

FITTING RESISTANCE TOO HIGH
Fitting faulty
E11 Vo

FUSION VOLTAGE TOO LOW
Not enough power from mains
E12 Vo

FUSION VOLTAGE TOO HIGH
Internal circuit not calibrated or faulty
E13
FUSION CIRCUIT INTERRUPTED
Power cord or output cables detached
during welding
E14
Io

FUSION CURRENT TOO HIGH
Fitting broken or circuitry not calibrated or
faulty
E15
FITTING OUT OF RANGE
Fitting is not in the right range
E16
SYSTEM ERROR
Electronic faults