4
Signet 0250 Setup Tool
Serial Number, Sensor Type:
• This sensor information is read from the Magmeter when you press the "Read" button.
Messages:
•
Displays messages related to the current selection. Error messages and procedure instructions will appear here.
• To repeat the same settings in another Magmeter, disconnect the Magmeter and connect the second Magmeter.
Note:
For 4-20 mA models, remove 24 VDC power before rewiring.)
• Click "Write" again.
Note:
All settings are lost when you exit the program. If the settings will be used again, click "SAVE". Name the fi le and save it on
the computer hard drive.
•
Read:
Read and display the existing settings from the Magmeter.
• Write:
Write from the display into the Magmeter.
• Save:
Save from the display to a fi le (*.bdf).
• Load:
Load from a saved fi le into the display.
• Factory:
Restores Application, Loop and Performance settings to original factory values.
Note:
The blue LED on the 3-0250 blinks during data communication between the computer and the sensor.
GND
Data
+5V from USB port
Blue LED indicates data transmission
Red LED indicates power
4.
Click "Write" to copy the new settings into the Magmeter.
Sensor Information
Controls
