GF EA 04, Инструкция по эксплуатации

Страница: 36 / 84

Installation Electrical actuator type EA04
36

In addition to these instruction manual, also follow manufacturer's specifications
on ball valve type 546.

Before installation, compare technical data of the actuator with the control and the
valve. Only install actuator if the data matches.

Before installation, check plugs and terminals for possible damage.

Make sure that no damaged parts are used.

Have installation and assembly only carried out by specialist staff.

If device is directly controlled:
- Fit a circuit breaker on site.
- Do not connect grounding conductor.
Requirements
- Cross section of the power lines max. 1.5 mm 2 .
- Fuse size: > 6 A.

Ensure that actuator is only connected to voltages that meet the requirements on
a protective extra low voltage circuit (PEVL).

Connect actuator, see Section 7.1 Connection diagram
7.3 Limit switches
The two end positions in the actuator have been factory set to 90°.