Rod locking
16
Assembly of RC2 variants of the Slimdrive SC product family
X
In the closed position of the moving leaves use
the manual unlocking (4) to move the rod locking
downwards so that the impressions of the locking
bolts can be seen on the tape (2).
6.3 Making the holes for the locking bolts
X
Turn the manual unlocking back again and slide
the door leaves to the open position.
X
Check the impressions (5) on the tape (2).
If necessary, apply the marking for the drill entry.
X
Drill through the floor sickle plate (1) at the
impressions with a 11-mm drill bit.
The locking bolts have to be flush with the drill
holes in the floor sickle plate.
X
Remove the tape (2).
X
Chamfer the drill holes.
X
Check whether the locking bolts (6) travel into
the floor sickle plate in a non-contact manner.
If the locking bolts touch the drill hole reveal:
X
Enlarge the drill hole and chamfer it if necessary.
