GEZE IQ box Safety, Руководство пользователя

Страница: 20 / 32

IQ windowdrives
20
Operation
3 Operation
3.1 Connecting the service terminal ST 220 and putting it into operation
M
A
IN
S
P
O
W
E
R
S
E
R
V
IC
E
C
A
S
E
POWER 24V
CHARGE
POWER 24V
ON
OFF
WINDOW
OPEN
FULL
ALARM
VENTILATION
LINBUS
ON
OFF CLOSE
CURRENT
FUSE 24V
WINDOW
ST220
12
10
11
ON
X
GEZE
14
16
13
8
7
6
4 3
1
2 9
5
B
K
B
N
G
Y
Y
E
A B S L
B
K
B
N
G
Y
Y
E
A B S L
A B S
L
B
K
B
N
G
Y
Y
E
A B S L
A
17
18
B S L
15
A B S
L
A B
11 11
15
0 V
open/24 V
closed
24 V
open/0 V
closed
SIGNAL LIN
0 V
open/24 V
closed
24 V
open/0 V
closed
SIGNAL LIN
Mains socket
230V / 50 Hz
or or
0 V
open/24 V
closed
24 V
open/0 V
closed
1 Service case (ID 142586)
2 MAINS POWER (mains connection, mains fuse, mains
switch)
3 POWER 24V DC ON/OFF switch
4 WINDOW OPEN/CLOSE switch (window/drive)
5 LIN-BUS ON/OFF switch (only for drives with LIN-BUS)
6 Switch ALARM/VENTILATION
(ALARM: Alarm speed, VENTILATION: ventilation
speed)
7 Connection for service terminal ST 220
8 Connection WINDOW (for single drive/window)
9 Ammeter (for display of the current consumption of
the drive/window)
10 Mains connection cable
11 Drive connection cable – Service case
12 Service terminal ST 220 (ID 087261)
13 Connection cable ST 220 mini DIN (ID 142581)
14 Drive with LIN-BUS (4-pin flat cable connector)
15 Drive with LIN-BUS (4-wire power supply cable,
3-wire power supply cable with F 1200+)
16 Drive without LIN-BUS (setting parameters not possible)
17 IQ box Safety
18 Connection cable IQ box Safety (ID 193394)
X
Before connection, make sure the DIP switch on the drives (solo/master/slave) is set correctly as otherwise the
data will not be able to be read and cannot be changed (refer to the IQ windowdrives wiring diagram).
à
Only the master can communicate with the ST 220. If a slave is connected to the ST 220, no text appears on the
display.
à
The locking drives Powerlock E 905 and E 906 must be connected to the device in connection with a chain
drive or spindle drive for the data to be read out.
à
Drive settings via the service terminal ST 220 can only be made when the drives are in their end positions.
à
If drives are connected in a synchro-network, they must be connected to the service case in compliance with
the wiring diagram (see the wiring diagram IQ windowdrives for the circuit diagram).
à A drive must be connected to the IQ box Safety to parameterize it.