GEZE ECturn Inside, Инструкция по установке и обслуживанию

Страница: 29 / 32

ECturn Inside
29
Commissioning
7 Commissioning
7.1 Collision test
X
Close the door carefully by hand and open it again.
During movement, no components may scrape or jam.
7.2 Opening restrictor
X
Fix the stop with thrust in the guide rail at a door opening of max. 110° (see „Installing the guide rail“ auf Seite
21).
X
During teaching, make sure that the door does not slam into the thrust but rather comes to a standstill before-
hand.
Alternatively, a door stopper can be installed.
7.3 Teach the drive
If no contact sensor (radio module, push-button switch or similar) is used:
X
Choose "Push & Go" in the parameter menu.
The teaching process is described in the ECturn wiring diagram.
X
Open the door a little.
X
Remove the control unit cover and allow to dangle from the cable.
X
Connect the display programme switch with the RS485 socket.
X
Request the Teach menu item (audible signal).
X
Remove the DPS connector.
X
Move the door into the closed position by hand (1st reversing point).
X
Move the door into the required open position by hand (2nd reversing point).
X
Move the door near to the closed position.
X
Connect the display programme switch with the RS485 socket.
X
Press the enter key and quit the teaching program (audible signal).
X
Pull the DPS connector off and replace the control unit cover.
X
Move the door into the closed position by hand (drive knows its start position).
8 Adaptation possibilities
8.1 During planning
The distance between the guide rail and drive can be enlarged by means of the lever with spindle extension (6
mm, 13 mm, 16 mm, 20 mm).
8.2 During installation (on site)
Adjustment of the distance between the drive (door) and the guide rail (frame) is not easy after installation has
been completed.
When the ECturn Inside is installed in a wooden door leaf, the distance can be reduced by shimming the motor
drive control if necessary.