GEZE ECturn Inside, Инструкция по установке и обслуживанию

Страница: 19 / 32

ECturn Inside
19
Installation
Electrical connection
X
Push the 6-wire cable (1) (2x 1 mm² for 24 V / 4x 0.25 mm² for door opener, contact sensor etc.) into the pre-
pared door passage from above and through the cable transition.
In the case of metal doors, this cable is already inserted when the door is built.
Route cable (1) along the motor drive control (arrow) to the control circuit board (2).
X
Do not shorten the cable (1) too much.
Leave the length of the cords not required so that all the terminals of the control circuit board can be reached if
necessary later.
X
Strip both 24V cords, fit with 1 mm² insulated wire end sleeves and connect to the connector.
X
Insert the connector into the control circuit board.