Geysers
INSTRUCTIONS FOR INSTALLATION
1. The Water Heater can be installed over a washbasin, a kitchen sink or in any other place where
it will not hinder you. Please note that all pipes must be placed on the bottom part of the water
heater.
2. The wall where the electric water heater is to be mounted must be able to withstand at least double
the weight of the water heater when fully filled with water. There must be no cracks or other signs
of damage on the wall.
3. If a bathroom is too small, the water heater can be installed in any other place unexposed to direct
sunlight and beyond the reach of moisture. However, to reduce heat loss, the location where the
water heater is installed must be as close to the taps as possible.
4. Select a position where the outlet point for hot water is close to the unit. This is necessary for
minimising heat loss in the hot water pipeline.
5. Keep a suitable height between the bottom of the storage water heater and the floor, such that the
unit causes no obstruction to movement and is also out of the reach of children. There should be
sufficient space below the unit for removing the apparatus plate, element, etc. for the purpose of
service.
6. After you have chosen a proper place to install the water heater, drill holes in the wall dimensionally
fit to anchor bolts (provided with the water heater). Next, fix the mounting strip on the wall with the
help of screws. Now, mount the water heater on the mounting strip.
7. Fasten a 230v/50Hz main socket with a single phase and three wires to the wall.
8. Do not install the electric water heater without multifunction valve (In Glassline models only).
9. Before installation the electric water heater check the water pressure of inlet connection. If it is
more that rated pressure installs pressure reduce valve before connecting with the inlet of heater.
10. Connect the electric water heater power cord with proper 16Amp - 3 pin power socket.
11. Do not connect with naked wires and ensure proper earthing connection.
12. Golden Prime strongly recommends the users/owners to use the ELCB (Earth-leakage circuit
breaker)
13. Ensure proper voltage (220V-240V) at the input point.
14. Golden Prime recommends using flexible pipe inlet and outlet points.
15. Do not install the electric water heater with concealed pipe
16. Do not tamper the default setting of multi-functional valve.
17. Switch OFF the power supply before closing the inlet tab.
18. Ensure water hardness should not be more than 100 TDS
19. Golden prime strongly recommends periodic service of water heater by authorized Service centre
