Gewiss Chorus GW 16 974CB, Руководство по установке

Страница: 21 / 56

21
E
N
G
L
I
S
H
Detailed information about how to set the thermostat parameters and how to program
with Easy Controller is given in the KNX/Easy ICE thermostat Programming Manual and
the Easy device (Easy Controller) Programming Manual (www.gewiss.com).
The device can be configured with the ETS software. Detailed information about the
configuration parameters and their values is given in the Technical Manual
(www.gewiss.com).
Setting the parameters and programming with Easy Controller
USER INSTRUCTIONS
Programming with ETS
If power fails on the BUS, the device will not carry out any action. When the BUS power
supply resumes, the thermostat will reactivate the conditions that were in place prior to
the power failure.
The thermostat is equipped with a back-up battery to keep the time in the case of a
power failure (max 1h)
The device does not require any maintenance. Use a dry cloth if cleaning is required.
CLEANING FUNCTION
This function makes it possible to temporarily inhibit the display so the glass plate can
be cleaned without sending any unwanted bus commands. The function can be
enabled/disabled as follows.
Enabling:
• touch the upper sector of the circular slider and the Mode button key at the same time
for at least 3 seconds.
• wait for a short beep (if the acoustic signal for glass cleaning is enabled) or the
contemporary flashing of the touch button keys (for the luminous signal that glass
cleaning has been enabled).
• wait for the count down to appear on the display (30 sec.) during which it is possible
to clean the plate.
Disabling:
• wait for the count down to reach zero.
It is possible to disable the cleaning function via ETS and activate/deactivate it with a
bus command and parameterisable duration.
Behaviour upon the failure and resetting of the BUS power supply
Maintenance