Gewiss Chorus Digital Vision, Техническое руководство

Страница: 74 / 104

Chorus Digital Vision - Technical System Manual
72
MAINTENANCE
If you need to reduce the size of a system, apply the corresponding procedure (manual or via a PC) described below.
Remember the manual procedure can be used in systems with no more than 34 apartments, 1 camera interface, 1 relay unit, 1 primary
front door unit, and 1 secondary front door unit. Using a PC with the
GW-VCT Configurator software, there are no limits but you must first
retrieve the original project file.
Removing a secondary front door unit manually
To remove a secondary front door unit, proceed as follows:
1. Restore the factory configuration for all the apartment units logically connected to the front door unit.
2. Eliminate the front door unit from the system.
3. Reconfigure the system as if it were new (refer to
Logic connections between outdoor and apartment units ).
Alternatively, you can simply remove the front door unit, without any further operations. In this case, the menus of the video entryphones
that were logically connected to it will continue to list it amongst the video control devices, but if it is selected nothing will be visible and
there will be no malfunctioning).
Removing a secondary front door unit via PC
To remove a secondary front door unit, proceed as follows:
1. Eliminate the front door unit from the project.
2. Disconnect the front door unit from the system, and remove it.
3. Reset all the devices, using the command in the special software menu.
4. Link up with the remaining front door units, one at a time, and download the configuration.
Removing an apartment unit manually
To remove an apartment unit, proceed as follows:
1. Disconnect the apartment unit from the system.
2. If the apartment unit was the only one in the apartment, you can leave the front door unit key programmed without causing any mal-
functioning. The video entryphone system will still work anyway, and you can thus avoid having to delete and reprogram the entire
system.
Removing an apartment via PC
To remove an apartment, proceed as follows:
1. Eliminate the apartment from the project. Its apartment units will automatically be eliminated.
2. Link up with the first front door unit.
3. Carry out the reset.
4. Download the configuration.
5. Repeat points 3 and 4 for the other front door units.
Reducing an existing system
`