001-14154-33-EN rev. 2
2 of 8
1. User Service Mode
This Mode allows the user to adjust certain lift parameters with the hand control
.
A) Turn off the lift by pulling the red cord (the green indicator light will turn off).
B) Press and keep down the PROG button on the hand control down (see Fig. 1).
C) While still pressing the PROG button, turn on the lift (see Fig. 2).
D) The green indicator light will flash and the buzzer will beep three times.
E) Release the PROG button.
F) The red indicator light will turn stay on, confirming that the lift is now in a service programming mode.
G) Use the UP button on the hand control to select the parameter you want to adjust. Each push on the
button will bring you to a different selection:
1 beep = Speed displacement
2 beeps = Length of the strap
3 beeps = Return to Charge/Return to Home - Enable/Disable
H) To confirm your selection, press the PROG button once.
1.1 Speed Adjustment
The horizontal speed displacement adjustment allows you to change
the speed of the lift. Four different speeds can be selected
.
A) Enter into User Service Mode and select the first choice (consult section 1).
B)
Use the LEFT button on the hand control to select the required speed as per the selection chart below.
Each push of the button allows you to go from one selection to the next
.
LIFT MODELS
SPEED SETTING
Maxi Sky 600 / V4 / V4i / V5 Duo
1 beep
2 beeps
3 beeps *
4 beeps
10 cm/sec
15 cm/sec
20 cm/sec
25 cm/sec
Maxi Sky 1000 / V10
1 beep
2 beeps
3 beeps *
4 beeps
10 cm/sec
14 cm/sec
16 cm/sec
20 cm/sec
* Default setting from factory
C) To confirm your choice of speed, press the PROG button
D) You can now choose a new program selection by pressing on the UP button on the hand control. To
return to normal use, turn off the lift and turn it back on.
