Recording and sending an ECG
77811011
PhysioMem
®
PM 100 2G
29
Step sequence of the display during transmission:
A – ECG in storage –
mobile transmission switched off
B – ECG in storage –
no mobile network
C – ECG in storage –
connection to mobile network established
D – ECG in storage –
connection to ReSTA established
E – ECG sent –
connection to ReSTA / status message
After sending, the main display is shown again.
Each ECG recording successfully sent is then deleted from the
storage.
The mobile transmission module is switched off automatically.
If the transmission of one or several ECG fails immediately after
recording, the transmission process is repeated automatically.
The device repeats the transmission at the following time intervals:
first repetition immediately after failure of the first transmission
process
three further repetitions each after 15 minutes
next repetition after 5 hours and after every 24 hours
NOTE
If the ECG data cannot be transmitted, e.g., because of a poor mobile
network connection, changing the location of the device is
recommended (e.g., go outdoors, change the side of the street, etc.).
Observe the times set by the repetition intervals described above. If
the mobile network connectivity is always insufficient in your area,
send the ECG from another area.
