GESTRA VKP 42, Оригинальная инструкция по установке

Страница: 22 / 32

22
Entering comments
If a steam trap has not be been checked yet you
can enter and save a comment on the test object.
The available comments are explained in the
following table. Most comments allow checking the
test objects.
Comment Meaning
Test object removed The test object is not installed in the system.
Test object not in operation The test object is not in operation.
Wrong name The name of the test object does not match the available test
object. Change the test object and the operating data.
Faulty gasket The test object has a faulty gasket. Replace the gasket.
Incorrectly installed The test object is not installed correctly. Install the test object
correctly.
Cold test object The fluid in the test object is cold. Check the settings of the
system and the test object.
Not accessible The test cannot be performed due to lack of space. Install the
test object differently.
Wrong type The type of test object differs from the one stored in the
database. Change the details in the database. You can also
change the information on the type during the test.
Test object insulated The measuring point on the test object is insulated and not
accessible. Remove the insulation from the measuring point.
Stop valve faulty A stop valve to the test object is faulty. Replace the stop valve.
Stop valve closed A stop valve to the test object is closed. Open the stop valve.
Test object OK The test object is functioning without an inadmissible loss of
steam. There is no banking up of condensate.
You may perform a test.
Test object faulty There is an inadmissible loss of steam from the test object.
Comment Comment freely. Enter any comment you wish.

To enter a comment touch the respective entry.

To test a steam trap with a faulty seal touch the
"Save" button.
 To test a steam trap of the wrong type select
the respective trap type stated in the list.
 Then touch the "Yes" button.