GESTRA UNA 46, Оригинальная инструкция по установке

Страница: 32 / 52

32
Troubleshooting
Problem Cause Remedy
The equipment is cold or only
warm to the touch.
Insufficient flowrate.
Insufficient thermal output of
the user.
The inlet or outlet shut-off valves
are closed. Fully open the shut-off valves.
The equipment is cold or only
warm to the touch.
Insufficient flowrate.
Insufficient thermal output of
the user.
The inlet, outlet or internals are
dirty. If fitted, operate the float-lifting lever.
Clean the pipes.
Clean the equipment.
Insufficient flowrate.
Insufficient thermal output of
the user.
The equipment is undersized. Install equipment with larger flowrate
capacity.
Insufficient flowrate.
Insufficient thermal output of
the user.
The differential pressure is too
small. Increase the steam pressure.
Lower the pressure in the condensate
lines.
Install equipment with larger flowrate
capacity.
Use a different equipment type.
Insufficient flowrate.
Insufficient thermal output of
the user.
The line leading to the equipment
does not have a gradient. Lay the condensate line with a gradient
so that the condensate is free to fall
towards the equipment.
Change the orientation of the pipeline.
Insufficient flowrate.
Insufficient thermal output of
the user.
Insufficient deaeration. Connect an additional air vent in
accordance with the instructions given by
the manufacturer.
Use a different equipment type.
Contact the manufacturer to find out
which trap type is the most suitable for
your application.
Insufficient flowrate You did not remove the sealing
plugs from the connections. Remove the equipment.
Remove the sealing plugs.
Mount the equipment.
The equipment is blowing off
live steam. Dirt deposits, sediments or
foreign particles have
accumulated in the equipment. If fitted, operate the float-lifting lever.
Clean the equipment.
If necessary, replace internal parts or the
whole equipment.