German pool PHD-100, Руководство пользователя

Страница: 9 / 28

Notice for Operation
P.9
- The appliance will not start operation until the blender jar is placed onto the unit base for safety purpose.
- Insert the measuring cup to the lid (align the arrow on the cup to the symbol on the lid and turn it to
position). Then press down the lid to the blender jar to close. To open, pull up by the flap of the lid.
- During operation, close the lid tightly to avoid injuries due to spilling or splashing of hot liquids.
- Wind excess power cord underneath the unit base to prevent the rubber foot from stepping on the power cord.
- When the food is too thick or there is too little liquid in the jar, the motor will be dragged to a low speed or stop
to operate. Hence, when blending thick and sticky food, start blending from low to high speed. If it is still unable
to blend, disconnect the power and stir the food inside the jar using a rubber stirrer to drive out the air trapped
in food. Then close the lid and switch on the blender to continue the operation.
- When overheating is sensed, the temperature monitoring system will be activated and would stop the operation
of the motor. In this case, put the appliance in a place with good ventilation to cool down for 45 minutes. The
system will be reset and you may resume the operation of the appliance.
- Keep hands and utensils out of the jar while the motor is running to prevent the possibility of severe personal
injury and/or damage.
- When making hot beverages or soups (such as soy milk, porridge, bisque, etc.), please ensure the lid is secured
tightly to the jar to prevent it from falling. Please be advised to start the operation at low speed first and then
gradually increase the speed, or simply use the “Pulse” mode.
- When making sauces (eg. almond sauce, jam and sesame sauce), stuffing and nuts, put in around 2 to 3 cups
of ingredients. The amount should neither be too much or too little. Keep the blending time within 2 min to
prevent any burnt smell due to overheating. Too much ingredients may lead to overloading and overheating of
the motor. In this case, wait till the motor temperature drops before operating again.
- Please put liquid and soft food into the jar before putting in hard food or ice cubes.
- When the operation finishes, please wait until the blade assembly comes to a complete stop before taking out
the blender jar.
- If you smell a burnt smell from the blender, stop operation immediately. It may be caused by the abrasion of
the rubber cushion base if it is not properly assembled.
- Do not operate continuously for over 10 minutes each time.