German pool EVB-120, Руководство пользователя

Страница: 6 / 35

P.11 P.10
• The manufacturer declines any responsibility for injury or damage, to person or property, as a
result of improper use or installation of this appliance.
• Heat, steam and moisture will be created during use of the appliance, take care to avoid injury
and ensure that the room is adequately ventilated. If the appliance is going to be used for
prolonged periods of time, then additional ventilation may be required.
• Please consult with your qualified installer if you are in any doubt about the amount of ventilation
that you will require.
• Make sure all control parts are working properly during installation.
• This built-in oven can be placed in high cabinets or walls. Plaint or glue that used in such furniture
shall be heat-resisting to prevent surface distortion or coating separation.
• Please install the oven according to the size given in the drawing below.
• The four screws showed in the drawing below are not allowed to be removed after the oven is fully
inserted into the cabinet.
Installation Instruction Installation Instruction
Exhaust vents
Air Inlet
557
50
≥ 590
≥ 560
35
≥ 415
595
406
545
450
23
Product Dimensions Aperture Dimensions
Height: 595 mm ≥ 590 mm
Width: 450 mm ≥ 415 mm
Depth: 580 mm ≥ 560 mm (min)
Positioning the appliance
• Ensure that the aperture that you will be fitting the oven into is of the size given in the above
diagram.
• The oven must be fitted into an oven housing with the ventilation cut-outs shown in the
“Ventilation requirements” section on the next page.
• Ensure that the rear panel of the furniture housing unit has been removed.