German Light Product Mini Patend, Инструкция по эксплуатации

Страница: 20 / 24

GLP German Light Production
(V1.11)
20
1. Strike the lamp (for example in the
LAMP
menu) and wait a while until full
intensity of the lamp.
2. Direct the beam straight on a flat and bright surface/wall (beam open, white, no
gobo, no effects).
3. If the Hot-Spot (brightest part of the beam) is not in the middle and the beam is
not max. bright, you can adjust this by turning the screws 1, 2 and 3. Try to find
the brightest position.
Remark: A complete even beam can't be reached because of the design of
the lamp.
6
6 Maintenance and Cleaning the
M
M
I
I
N
N
I
I
P
P
A
A
T
T
E
E
N
N
D
D
It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid
residues must not built up on or within the fixture. Otherwise the fixture's light-output will
be significantly reduced. Regular cleaning will not only ensure the maximum light-output
but will also allow the fixture to function reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended, under no circumstances should alcohol or solvents be used!
The inside optical system should be maintained only by authorized persons. Please
contact your local dealer.
6.1 Safety Regulations
•
Pull out the main plug!
•
Wait min. 20 minutes after the last operation to cool down the fixture.
•
Before you put the
M
M
I
I
N
N
I
I
P
P
A
A
T
T
E
E
N
N
D
D into operation close the casing, otherwise
your retina can be hurt!
6.2 Circumference and Interval (rule-of-thumb)
The contamination of the fixture depends on the environment details. Therefore
no general guidelines can be given. From this it follows that the intervals are only
suggestions from our practice experience.