Gerber Sabre Engraver Option, Руководство пользователя

Страница: 8 / 29

Welcome 3
Assembling the engraver and mounting plate
Before installing and using the engraver, you must attach the engraver and
casting to the mounting plate. This assembly operation is only performed once
−
afterward, the mounting plate is considered part of the engraver.
The mounting plate, shown below, has guide pins on both the front and back
surfaces. Attach the mounting plate to the motor casting in the orientation shown
in the illustration (the lower guide pins on the front going into the back of the
casting so that the mounting plate extends above the top of the casting).
After sliding the guide pins into the back of the casting, secure the casting to the
mounting plate using four M6 x 25 screws and washers provided in the kit. To
gain access to the two screw holes on the right, open the engraver cover.