Gerber Sabre Engraver Option, Руководство пользователя

Страница: 26 / 29

Maintaining the Engraver Option 21
Cleaning the nose cone and micrometer dial
WARNING: Set the engraver motor power switch to off before performing
this procedure.
1. Remove the foam ring and
pressure foot from the vacuum
nose cone (if installed).
2. Unscrew the installed nose cone
locking ring by turning it
counterclockwise.
3. Unscrew the micrometer dial by
turning it clockwise until it
separates from the spindle
4. Blow compressed air on the nose cone, locking ring, foam ring, pressure
foot, and micrometer dial.
5. Clean the inside threads on the micrometer dial and the outside threads of
the bottom of the spindle with the brush from the accessory kit and a clean,
lint-free cloth moistened with isopropyl alcohol.
6. Reassemble the micrometer and nose cone.
Cleaning and lubricating the spindle
WARNING: Set the engraver motor power switch to off before performing
this procedure.
1. Remove and clean the nose
cone and micrometer dial as
described above.
2. Remove the two screws
securing the micrometer dial
pointer to the spindle
housing.