Gerber Sabre Engraver Option, Руководство пользователя

Страница: 12 / 29

Installing the Engraver Option 7
Changing the engraver nose cones
The engraver is shipped with a standard nose cone installed. The Engraver
Option kit contains a vacuum nose cone, pressure foot with foam ring, and
vacuum hose for use with the separately-purchased Gerber Engraver Vacuum
Option.
CAUTION: Do not install the vacuum nose cone without connecting it to a
vacuum source such as the Gerber Engraver Vacuum Option. Engraving
chips may fill the nose cone, possibly damaging the cutting tool. For more
information regarding the Engraver Vacuum Option, contact the Gerber
Router Support Group.
WARNING: Set the engraver motor switch to off before changing the nose
cone.
To remove the standard nose cone, first remove the cutting tool, then unscrew
the locking ring by turning it counterclockwise. To install the vacuum nose cone,
screw the cone's locking ring clockwise onto the bottom of the micrometer dial.
To install the pressure foot, put the foam ring on the pressure foot then snap it
into the bottom of the vacuum nose cone.
For information on connecting the vacuum hose and using the Gerber Engraver
Vacuum Option, refer to the literature supplied with the Engraver Vacuum
Option.