September 2010
Manuale Operatore Piegatrice Mondial
5
Warranty
Thanks for purchasing the GERA Cut & Fold folder; to enable the
warranty and get further informations about the roduct and services,
please perform the folder registration through the website
http://www.gera.it/GERA folder registration.htm
General Overview
Referring to the final folded pocket in basso, it is possible to choose
between following folding programs:
210 fold “a”=210 mm
190 fold “a”=190 mm
190+m
fold “a”=190 mm m=20mm (*)
fold “b”=297 mm
a
b
m
p
C
(*)
only if the folder is provided with the table with sensor , option at
the moment not available
Folder USE
Before Folding
Use the extractable support to put the drawings to be trimmed before
folding operations. Lift up the bar and block it in horizontal position .
Folding operations overview.
After put the drawings on the support bar, trim the drawing edge short
side where is located the title block, choose the fan folding program di
(190 o 210), feed the copy for the fan folding with front title block; take
again the fan folded copy and trim the two shorter edge then feed the
copy from the shorter side for the cross folding.
All the operations above are described in particular below.
