7. Enabling External Control the Beeper and LED
You can change the default settings of the LED and the beeper by enabling a GV-AS400 /
410 / 810 to externally control the LED and Beeper. The GV-AS Controller and the reader
need to be connected through Wiegand interface. You will have to:
1. Enable external control of the GV-DFR1352’s Beeper and LED by using the
GV-Reader
Config AP
. Refer to
7.1 Setting up Beeper and LED on GV-Reader Config AP
.
2. Wire the Beeper, Red LED and Green LED from GV-DFR1352 to GV-AS400 / 410 / 810.
3. Specify the Beeper and LED settings for each door through the Web interface of GV-
AS400 / 410 / 810.
7.1 Setting up Beeper and LED on GV-Reader Config AP
To enable the external controls of the Beeper and LED on GV-Reader Config AP, the reader
needs to be connected to a computer through GV-COM, GV-Hub or GV-NET/IO Card V3.1.
1. Install
GV-Reader Config AP
from the Software CD.
2. Start the
GV-Reader Config AP
and select the COM port that is connected to GV-
DFR1352.
Note:
To see how to install the GV-Reader Config AP and how to identify the COM port of
the reader, refer to
6.1 Defining the ID Number and Setting the Reader to Slave
earlier in
this installation guide
April 24, 2014
8