GEOSUN eFix R1, Инструкция по эксплуатации оборудования

Страница: 24 / 41

18
Battery installing

Installing: put the battery into the battery slot with the “Close” end pointing to
the inserting holes, and then push it towards the inserting hole to lock the
battery well. Finally install the battery cover.

Uninstalling: take off the battery cover first, push the battery towards to
“Open” direction, and then take it out.
Charging
Please use the special charge in the eFix R1 standard package to charge the battery in the
allowed certain temperature range 0℃
～
40℃. For the first time using, please do not charge
the battery until using up the remained power in it. And then charge it 12 hours each time
for the first three times. After the first three times, the charging time should be enough as
long as 8 hours every time normally. And make sure only charge the battery after it has
been used up. Furthermore, if the battery is not used for a long time, it should be charged
once every month to keep it active.
The eFix R1 charger can charge two batteries at the same time. Please put the battery onto
the charger with the “Close” pointing to the indicator led of the charger as below figure,
and then push it until it is locked well.
When the “Charging” indicator is on in red, it means the battery is being charged; when
green, it means the battery is charged full. But now please keep charging the battery for
more 1~1.5 hours, then take the battery off.