Georg Fischer RA 21, Руководство по эксплуатации

Страница: 17 / 28

13
GEORG FISCHER +GF+
6.3 Adjusting the additional cutter
Simultaneous cutting and bevelling of steel pipes
up to a wall thickness of 4.5 mm is possible.
!
Insert the pipe in the
vise.
! Move the pipe
almost up to the
additional cutter.
! Clamp the pipe in
the vise.
! Release the lever (1)
and set the stop (2)
to position 2".
Do not tighten.
! Raise the motor of
the pipe cutter as if
to start cutting, until
the cutter covers the
wall of the pipe.
! Tighten the lever (1).
!
Do a test bevel and
check the result (see
section 6.6).
1/4
3/8
1/2
3/4
1
1 1/4
1
1/2
2
1
2
Move the
stop (2) a
little to the
right
Move the
stop (2) a
little to the
left
Bevel OK