Geometrics Memory-Mag G-856AX, Руководство по эксплуатации

Страница: 14 / 60

Geometrics, Inc
.
G-856AX Operation Manual
8
horizontally on its side. For now, mount it vertically as shown in Figure 4 a.
a b
Figure 4. Staff / sensor assembly.
4) Remove the console cover by flipping the plastic tabs on its sides outward and
sliding the cover completely off as shown in Figure 5 \a and b. Depending on the
G-856AX version either a) Install fresh D-cell alkaline batteries or b) connect the
internal rechargeable gel-cell battery. Gel-cell batteries are held in place with
Velcro straps as shown in Figure 5c. Reinstall the cover before proceeding.
Clasps securing
console case
a
Slide consol cover off
to access batteries
b
Velcro straps
securing
batteries
c
Figure 5. Console battery compartment.
5) The magnetometer is shipped with the signal cable attached to the sensor. If this
cable is not connected to the sensor connect it as shown in Figure 3b. The sensor
cable terminals are secured to the studs with brass washers and brass nuts. Do not
substitute other hardware for these parts unless then completely non-ferrous.
Tighten the terminal nuts finger-tight and then tighten an additional 1/8
th
turn
(between 18 in-lb and 24 in-lb). Connect the signal cable to the magnetometer.
6) Put the console harness on as shown in Figure 6a. Hold the console to your chest