GeoMax ZONE20 H, Руководство пользователя

Страница: 20 / 30

Zone20 H
| 20
Batteries
6 Batteries
Description The Zone20 H can be purchased with alkaline batteries or a rechargeable Li-Ion battery pack.
The following information is appropriate only to the model you have purchased.
6.1 Operating Principles
First-time Use /
Charging Batteries • The battery must be charged prior to using it for the first time because it is delivered with an energy
content as low as possible.
• The permissible temperature range for charging is between 0°C to +40°C/ +32°F to +104°F. For
optimal charging, we recommend charging the batteries at a low ambient temperature of +10°C to
+20°C/+50°F to +68°F if possible.
• It is normal for the battery to become warm during charging. Using the chargers recommended by
GeoMax, it is not possible to charge the battery if the temperature is too high.
• For new batteries or batteries that have been stored for a long time (> three months), it is effectual
to make only one charge/discharge cycle.
• For Li-Ion batteries, a single discharging and charging cycle is sufficient. We recommend carrying out
the process when the battery capacity indicated on the charger or on a GeoMax product deviates signif-
icantly from the actual battery capacity available.
Operation / Discharging • The batteries can be operated from -20°C to +55°C/-4°F to +131°F.
• Low operating temperatures reduce the capacity that can be drawn; high operating temperatures
reduce the service life of the battery.
6.2 Battery for Zone20 H
Charging the Li-Ion
battery pack step-by-
step The rechargeable Li-Ion battery pack on the Zone20 H can be charged without removing the battery pack
from the laser.

The battery pack reaches a full charge in approximately 5 hours if completely empty. A one-hour
charge should allow the Zone20 H to run for a full 8 hours.
Step Description
1. Slide the locking mechanism on the battery compartment to the centre position to expose the
charge jack.
2. Plug the AC connector into the appropriate AC power source.
3. Connect the charger plug into the charge jack on the Zone20 H battery pack.
4. The small LED next to the charge jack flashes indicating that the Zone20 H is charging. The
LED is on solid when the battery pack is fully charged.
5. When the battery pack is fully charged, disconnect the charger plug from the charge jack.
6. Slide the locking mechanism to the left to prevent dirt from getting into the charging jack.
4
011256_001
1
3
2
5
6