Geokon GeoNet 8900 Series, Инструкция по эксплуатации

Страница: 36 / 56

24 | MODEL 8800-2-4B ADD-ON MODULE | GEOKON
5. MODEL 8800-2-4B ADD-ON MODULE
5.1 INTRODUCTION
Model 8800-2-4B (Ethernet compatibility) is an add-on module for the mesh
supervisor to allow the end user to easily add remote communications and data
download functionality.
Each module comprises a weather proof enclosure 305 x 254 x 152 mm (12" x
10" × 6") in size, a 7 amp hour rechargeable battery, a charger, and the
necessary cables to interface with a GeoNet supervisor.
When an add-on module is paired with a mesh supervisor, the supervisor is
powered by the rechargeable battery inside the module. The charge level of the
battery can be monitored using the Agent software.
5.2 INSTALLATION OVERVIEW
Modules are shipped with the batteries uninstalled and the fuse distribution
board switch in the OFF position. To deploy modules, install the batteries and set
the switch to the ON position.
Install D cell batteries in the supervisor and set the battery switch to the
appropriate setting to ensure communication between the supervisor and the
nodes will not be interrupted if the battery level drops. See Section 3.2.1.
5.3 IP ADDRESS CONFIGURATION
GEOKON
sets the module to communicate with a GeoNet mesh supervisor;
however, the user must finish the setup so that it works with their network.
Configure an IP address by following the instructions below.
Note: The following steps should only be performed by your network
administrator. NPort Administrator (on CD) should be installed and used to
configure the required IP changes.
1. Connect a computer to the module via the Ethernet Port.
2. Open NPort Administrator and click Search . (By default, the MOXA 5110A
IP Address 192.168.127.254 will be displayed.)
3. Double-click on the IP Address under the configuration window.
4. In the configuration window, click on the Network tab.
5. Check the boxes next to Modify IP address and Modify Netmask .
28:
FIGURE 28: Nport Configuration