Geokon 6150F, Инструкция по эксплуатации, Страница: 13 / 32

MODEL 6150F MEMS DIGITAL ADDRESSABLE IN-PLACE INCLINOMETER | INSTALLATION | 5
2.2.4 SENSOR INSTALLATION
1. Insert the bottom wheel assembly into the casing, making sure to orient the
fixed wheel correctly (see Section 2.2.3).
2. Using the safety cable, lower the bottom segment into the casing hole, until
the bottom sensor is at the top of the casing.
3. Hold the segment in place at the top of the casing using vice-grips or a
similar method.
4. Plug the male connector of the bottom sensor into the female connector of
the sensor above it.
Caution! When connecting the sensors, make sure to align the two nubs
on the outside of the female connector with the nub on the outside of the
male connector. This will ensure that the pins and holes on the interior of
the connectors align correctly. Push the male and female connectors
together until they are completely mated.
FIGURE 10: Cable Connection Detail
5. Tape the signal cable to the tubing, if desired. The connectors may be taped
together for additional security.
6. Using the safety cable, lower the bottom segment into the hole, until the
next sensor is at the top of the casing. Make sure to orient the A+ direction
of the sensor correctly when inserting it into the casing.
7. Continue to add segments to the string. Connect the sensor cables together
and lower the string into the casing, until the uppermost sensor is aligned
with the top of the casing.
2.2.5 CONNECTING THE SUSPENSION BRACKET
Attach the suspension bracket to the top sensor’s wheel assembly via one of
two methods: use a cable (sold separately), or use the connector tube provided.
FIGURE 12: Suspension via Tube FIGURE 11: Suspension via Cable
Eye Bolt
Eye Bolt
150 mm
above ground level
Below ground
Casing
Connector
Tube
Suspension
Bracket