GENTILIN C 330/50, Инструкция по эксплуатации

Страница: 39 / 198

17
7
3 1 2
8
9
9
MOD. CS 240/5+5 MOD. CS 240/03
9
MOD. CS240/24 - CS240/50
EN
Rev. 00 - 12/2013 - Cod. CM31710 - Instruction manual
Compressor Mod. CS240
1)
Connect the appliance to the power supply
(8)
by plugging it in.
2) Switch on the appliance using the “ON-OFF” switch (3) ensuring it is in the “ON (I)” position (the appliance is operational
until it reaches a maximum operating pressure of 10 bar, after which, it switches off automatically.
3)
Regulate the outlet pressure using the relevant regulator
(2)
according to the utensil used and type of work. Control
the pressure displayed by the relevant gauge (7) .
Do not FUllY SCREW tHE oUlEt PRESSURE GaUGE
(2) oR YoU RiSK DaMaGinG tHE MEMEBRanE.
4)
Connect the utensil to the air pipe (extension).
5) Connect the air pipe (extension) to the air outlet spigot (1) .
aiR PiPES (EXtEnSionS), ConnECtionS anD UtEnSilS
WHiCH ConFoRM to DEtailS aS SPECiFiED in tHE
inStRUCtion ManUalS PRoViDED BY tHE RElEVant
ManUFaCtURERS MUSt BE USED.
it iS StRiCtlY FoRBiDDEn to USE UnSUitaBlE aiR HoSES
(EXtEnSionS), FittinGS anD toolS tHat Do not CoMPlY
WitH CURREnt REGUlationS.
6) Carry out operations (the appliance will re-start automatically
in the instance where the operating pressure falls below 7 bar).
7)
Upon termination of operations, switch off the appliance as
described in Paragraph 27.
27. APPLIANCE DEACTIVATION
At the end of operations, switch off the appliance as follows:
1)
Switch off the appliance using the “ON-OFF” switch (3) ensuring it is set to “OFF (0)”.
2)
Disconnect the appliance from the power supply
(8)
by unplugging it.
3)
Disconnect the utensil from the air pipe (extension).
4) Disconnect the air pipe (extension) from the appliance air outlet spigot (1) .
5)
Drain the tank condensate pump only once the work cycle is terminated
(9)
.