18/03/2013 Genlab Ltd
OP INS PRIME RANGE Issue 1
Page 5 of 6
7.
GENERAL
Mop up any spilled liquid from the floor of the unit.
Do not place samples on the chamber floor.
Take the normal precautions not to allow water to come into contact with the electrical
components.
The outer surfaces can be cleaned with a warm, damp, soapy cloth or any proprietary
cleaner suitable for a painted surface (do not use solvents or harsh abrasives).
The work chamber may also be cleaned as above.
8.
Error Messages
Er1 Overheat trip Indication
Press reset button to reset when oven cooled down
Er2 Temperature High (10 deg C over setpoint – software alarm check)
Press start / stop to reset
Er3 Temperature Low (10 deg C under setpoint – software alarm check)
Press start / stop to reset
Er4 Probe failure, contact factory for replacement probe
Press start / stop to reset after new probe installed
Note:
The right-most decimal point of the ‘setpoint display’ is illuminated as an indication that power is
being applied to the heating element. This point will flash as it reached set point as a
representation of the PID values tuning to the desired set point.
