Genius Scanner
14
1. Click on the START button, and then choose PROGRAMS, Genius Scanner
(the model name of your scanner) and then SCANNER UTILITY.
2. Once the Scanner Utility window is open, locate and click on the USB button
shown below:
This will check the status of your USB hardware and software configuration.
3. If there is a problem with the installation, the following message will appear:
4. If the connection is OK, the following window will be displayed:
A
A
l
l
i
i
g
g
n
n
i
i
n
n
g
g
t
t
h
h
e
e
S
S
c
c
a
a
n
n
n
n
e
e
r
r
In most cases, the scanner doesn’t need to be aligned but there are instances
when the alignment might be required. You need to align the scanner only if parts of
the scanned document are missing from any of its edges. For example, the heading of
a document might be missing from the top edge after the document has been scanned.
To align the scanner, follow the steps below:
1. Place a photograph on the top right side of the scanner glass (near the back
of the scanner). Please note that only part of the photograph will be scanned.
2. Click on the SCAN button
. Part of the photograph will be displayed
in the ALIGNMENT window.
3. Click on the ALIGN POSITION buttons until the top left corner of the scanned
photograph aligns with the top left corner of the preview window.
4. Click on the check mark button
when the alignment has been
completed.
L
L
a
a
m
m
p
p
C
C
o
o
n
n
t
t
r
r
o
o
l
l
The scanner’s lamp may be turned ON and OFF manually in the Scanner Utility
program. While there, you can also set a timer to turn the lamp off after the scanner
has been idle for a designated amount of time.
