Genius AMICODE 868, Руководство пользователя

Страница: 7 / 20

5
ENGLISH
3.1. Inputting new PASSWORD
Procedure for inputting or modifying the programming PASSWORD:
Keys 1+3
3 beeps
Keys 7+8
3.2. Inputting a new PIN code
Procedure for inputting or modifying the PIN code:
3 beeps
Keys 8+9
3 beeps
Input the old
programming
password
1 long beep
Input the new
password
2 beeps
Re-input the new
password
1 long
beep
Exit from
programming
(keypad OFF)
Keys 1+3
3 beeps
Keys 4+6
3 beeps
Input the
programming
password
1 long beep
Input the new
PIN code
2 beeps
Re-input the new
PIN code
1 long beep
Exit from
programming
(keypad OFF)
3.3. Transmission of system code
IMPORTANT:
This operation is possible only if the keypad is configured as a MASTER (standard setting), otherwise it will emit
an error signal (4 consecutive beeps).
The system code of the four channels can be transmitted from the keypad to the Amigo receiver board, to the Amigo 868 remote
controls, or to a second keypad. Code transmission procedure:
Keys 1+3
3 beeps
Keys
1+2
3 beeps
Input the
programming
password
1 long beep
Press and hold down the key of the channel you wish
to transmit, and see the following instructions
according to the device due to receive the code.
Exit from
programming
(keypad OFF)
• Transmission to the Amigo receiver board: Press and hold down the push-button relating to the channel on which you wish to
save the system code. Check if the LED on the receiver stays lighted for a few seconds to confirm due in-memory storage.
• Transmission to an Amigo remote control: Press and hold down the push-button on which you wish to copy the system code,
bringing the two devices into contact. Check if the remote control LED flashes about twice before going OFF, to confirm due in-
memory storage.
• Transmission to a second keypad: Type in the PIN Code on the keypad selected to learn the system code, then press and hold
down the push-button relating to the channel on which you wish to save the code. Make sure that the keypad that received
the system code sounds a long beep to confirm in-memory storage. To definitively save the channel, dial the PIN code and press
twice in succession the key on which the system code was stored.
3.4. Deletion / reset
You can return to the initial settings at any time by resetting the keypad.
IMPORTANT:
This operation deletes the PIN code, the programming PASSWORD and all the saved system codes, taking the
keypad back to its factory condition.
Steps for resetting the keypad:
Keys 1+3
3 beeps
Keys 7+8
3 beeps
Keys 2+0
3 beeps
Input the
programming
password
1 long beep
Deletion done
Exit from
programming
(keypad OFF)
3.5. Changeover to SLAVE
This operation disables both transmission and reception of system codes by the keypad. Moreover, you can no longer access the
programming stage to modify the PIN code and the programming PASSWORD.
IMPORTANT:
This operation is not reversible: when the keypad has changed over to SLAVE, it cannot be changed back to
MASTER.