8
9.2. Electrical safety
a)
It is necessary that the power tool plugs are adapted to the base. Never modify the plug in any way. Do not use
adapters with earthed tools. Unmodified plugs and adapted bases reduce the risk of electric shock.
b)
Avoid body contact with earthed earth as pipes, radiators, stoves and refrigerators. There is an increased risk of
electric shock if your body is in contact with grounded surfaces.
c)
Do not expose power tools to rain or wet conditions. The penetration of water into a tool increases the risk of electric shock.
d)
Do not misuse the cable. Do not use the cord for carrying, pulling or unplugging the tool. Keep the cord away
from heat, oil, edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
e)
When operating a tool outside, use an extension cord suitable for outdoor use. Using a cable suitable for
outdoor use reduces the risk of electric shock.
f)
If it is necessary to use the tool in a location with moisture, use a secure supply with residual current device
(RCD). The use of an RCD reduces the risk of electric shock.
9.3. Security staff
a)
Be aware of what you are doing and use common sense while using the tool. Do not use a tool when you are
tired or under the influence of drugs, alcohol or medication. A moment of distraction in the use of a tool can cause
serious personal injury.
b)
Use safety equipment. Always wear eye protection. Safety equipment such as dust masks, non-slip safety
shoes, helmets or acoustic protection used in appropriate conditions reduce injuries.
c)
Avoid accidental starting. Make sure that the switch is in the off position before plugging in to power or battery,
collect or transport. Carrying tools with your finger on the switch or plugging the machine with the button in on
position can cause accidents.
d)
Remove any adjusting key before turning the tool on. A key left attached to a rotating part of the tool may result
in personal injury.
e)
Do not rush. Maintain proper footing and balance at all times. This allows better control of the tool in unexpected situations.
f)
Dress appropriately. Do not wear loose clothing or jewelry. Keep hair, clothing and gloves away from moving
parts. Loose clothing, jewelry or long hair can get caught in moving parts.
g)
If devices for connecting equipment for extraction and dust collection are supplied, make sure they are
connected and properly used. Use of dust collection can reduce risks due to dust.
9.4. Use and maintenance of the tool
a)
Do not force the tool. Use the right machine to the application being performed. A suitable tool will do the job
better and more safely if used for the purpose for which it has been built.
b)
Do not use the tool if the switch does not allow to turn it on or off. Any machine that can not be controlled by
the switch is dangerous and must be repaired.
c)
Disconnect the power source supply or battery block machine before changing accessories or before storing the
machine. These preventive safety measures reduce the risk of accidental starting of the machine.
d)
Keep the tool off away from children and do not allow to be used by people who are not familiar with the
machine. Tools are dangerous in the hands of inexperienced.
e)
Make sure the machine maintenance and moving parts are not aligned or blocked, that it has not broken parts
or any other condition that may affect the operation of the tool. In case of damage, take the machine to a repair
service before using it again. Many accidents are caused by poorly maintained machines.
f)
The machines used for cutting with sharp pieces that have had good maintenance are less likely to become
blocked and are easier to control.
050180 User Manual EN.indd 8
12/9/16 9:52