5
4.3. Drilling (B4)
To drill, put the adjustment wheel for the torque in the last grade “drill”, in grade “drill” the safety clutch is
deactivated. When drilling, the maximum torque is available.
4.4. Switch the direction of rotation (B5)
The slide switch over the on/off switch allows to choose the rotation direction of the drill / driver with battery and
prevent accidental starting. You can select clockwise rotation or leftward. To prevent damage to the gear, do not
change the direction of rotation if the machine is running. In the case that the slide switch is in center position,
switch on / off crashes.
4.5. Switch on / off (B5)
The switch on / off allows you to adjust the speed continuously, depending on the intensity with which the switch
is pressed.
4.6. Switching speed 1 to speed 2. Fig. 4 / Item 6 (B7)
Note:
Press the 6 gearshift lever only in the stability of the device.
In the first gear (gear selector position 6 in 1) a speed of 400 min-1 and torque is achieved. This setting is suitable
for all fastening applications.
In the second gear (6 speed selector switch position: 2) a speed of about 1400 min-1 is achieved to carry out
drilling operations.
4.7. Display battery status (B8)
Three color LEDs indicate the status whenever the ON / OFF button (4) is pressed.
>
All LEDs are lighted: the battery is fully charged.
>
Yellow and red LEDs lighted: the battery has enough charge.
>
Red LED lighted: the battery is empty, you should charge it.
4.8. LED display (B8)
The LED (10) light can illuminate the screwing and unscrewing area under unfavorable lighting conditions. The LED
(10) light illuminates automatically, at the time the switch on / off (4) is pressed.
4.9. Tool change (B9)
ATTENTION! For works (eg changing tools, maintenance, etc.) on the cordless screwdriver, put the
switch in the direction of rotation (3) in middle position.
>
The cordless screwdriver is equipped with a quick coupling mandrel (9) with automatic lock on.
>
Unscrew the mandrel (9). The overture of the mandrel (a) must be large enough to house the connector
(drill or screwdriver).
>
Select the appropriate tool. Put the connector as far as possible from the overture of the mandrel.
>
Adjust the mandrel and then check if the connector is well supported.
4.10. Screwing
Use preferably automatic centering screws (eg Torx, Phillips head) to ensure complete safety work. Ensure that
the shape and size of the screw are appropriate. Perform rotation torque control as described above: depending
on the size of the screw.
050180 User Manual EN.indd 5
12/9/16 9:52