Genie Super-Straddle, Руководство по обслуживанию

Страница: 21 / 43

September 2016 Service Manual
Checklist B Procedures
Part No. 115429 Super Straddle 13
Checklist B Procedures
B-1 Inspect All W elds
B-1
Inspect All Welds
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Weld inspections are essential to safe machine
operation and good machine performance. Failure
to locate and repair damage may result in an
unsafe operating condition.
1 Visually inspect the welds in the following
locations:
• Winch mounting plate
• Loading wheels
• Straddle frame/end frames
• Ladder
• Outrigger sockets
B-2 C heck the Winch Oper ati on B-2
Check the Winch Operation
Genie requires that this procedure be performed
every 250 hours or quarterly, whichever comes
first.
Detection of damage to the winch is essential to
safe machine operation. An unsafe working
condition exists if the winch is damaged or not
operating correctly. A daily check of the winch
operation allows the inspector to identify changes
in the operating condition of the winch that might
indicate damage.
1 Visually inspect all the winch components for
damage.
2 Raise the straddle frame through a partial
cycle and release the winch handles.
Result: The winch should operate
smoothly, free of hesitation or binding. The
load should not lower when the handles are
released.
3 Fully lower the straddle frame.
Result: The winch should operate smoothly,
free of hesitation or binding.