Genie Super-Straddle, Руководство по обслуживанию

Страница: 23 / 43

September 2016 Service Manual
Checklist C Procedures
Part No. 115429 Super Straddle 15
Checklist C Procedures
C-1 Inspect the Wear Pads
C-1
Inspect the Wear Pads
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining the wear pads in good condition is
essential to safe machine operation. Wear pads on
the Super Straddle are used to provide a uniform fit
between the end frames and straddle frame, as
well as a means to prevent wear to the frame
assemblies during the extend and retract
functions. Over time, it may be necessary to replace
the wear pads to ensure good machine
performance. Wear pads are placed on the outer
ends of the straddle frame assemblies and should
be replaced when the surface of the wear pad is
reduced by 25% or more. Continued use of worn
wear pads may result in component damage and
unsafe operating conditions.
1 Measure the wear pads. See Repair
procedure,
How to Access the Wear Pads
.
C-2 Repl ace the Friction Disks C-2
Replace the Friction Disks
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining the winch is essential to good
machine performance and safe operation. An
unsafeworking condition exists if the winch has
excessive wear and/or does not operate smoothly,
free of hesitation and binding.
1 Replace the winch friction disks. See Repair
procedure,
How to Disassemble a One-speed
Winch
.