Genie S-80, Руководство по обслуживанию

Страница: 50 / 353

3 - 20 S-80 • S-85 • S-80X Part No. 122985
Section 3 • Scheduled Maintenance Procedures February 2012
CHECKLIST B PROCEDURES
3 Locate the engine tray anchor hole on the
turntable.
4 Install the bolt that was just removed into the
anchor hole to secure the engine tray from
moving.
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.
5 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
•
Engine wiring harness
6 Open the turntable cover at the ground controls
side of the machine.
7 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
•
Battery area wiring
•
Inside the ground control box
•
Hydraulic manifold wiring
•
Hydraulic oil cooler wiring
8 Inspect for a liberal coating of dielectric grease
in the following locations:
•
All wire harness connectors to
ground control box
9 Start the engine from the ground controls and
raise the boom above the turntable covers.
10 Inspect the turntable area for burnt, chafed and
pinched cables.
11 Lower the boom to the stowed position and turn
the engine off.
12 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
•
Cable track on the boom
•
Cables on the boom and jib boom
•
Jib, rotate, level manifold
•
Inside of the platform control box
13 Inspect for a liberal coating of dielectric grease
in the following location:
•
All wire harness connectors to
platform control box
14 Remove the engine tray retaining fastener from
the engine tray anchor hole at the pivot end of
the engine tray.
15 Swing the engine tray in towards the machine.
16 Install the engine tray retaining fasteners.
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.