Operator's Manual
Second Edition
y
First Printing
Inspections
34
S-100HD • S-120HD
Part No. 1261387
Test Limited Drive Speed
66
Press down the foot switch.
67
Raise the boom to 10° above horizontal.
68
Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 30 cm/s.
Note: The machine will travel 12 m in 40 seconds.
69
Lower the boom to the stowed position.
70
Extend the boom 1.2 m.
71
Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 30 cm/s.
Note: The machine will travel 12 m in 40 seconds.
If the drive speed with the boom raised or extended
exceeds 30 cm/s, immediately tag and remove the
machine from service.
72
Raise the boom to horizontal. Extend the boom
as far as it will go.
73
Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the boom fully extended should not exceed
4.5 cm per second.
Note: The machine will travel 12 m in 270 seconds.
Test Emergency Controls
74
Shut the engine off.
75
Pull out the red Emergency Stop button to the
on position.
76
Press down the foot switch.
77
Simultaneously press and hold the
emergency power button and
activate each function control
handle, toggle switch or button.
Note: To conserve battery power, test each function
through a partial cycle.
Result: All boom functions should operate.
Drive functions should not operate with
auxiliary power.
Test the Lift/Drive Select Function
78
Press down the foot switch.
79
Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will in the direction indicated on the
control panel.
