TCP/IP Setup
Setup -
Network Type
Define network IP address type from the Static Mode for the
fixed IP or the Dynamic Mode by the dynamic IP address.
If you select the Static Mode, you must fill out IP Address,
Subnet Mask, Gateway, DNS Server and all ports. If you
select the Dynamic Mode, the IP address will be allocated
automatically by DHCP equipment. If you click the Apply
button to update changes, the system will be re-booted.
In this case, you have to reconnect the camera using new IP
address.
IP Address
Define the IP address. The address is consisted of four
numbers separated by dots and the range of each number
is from 0 to 255.
Subnet Mask
Define the Subnet Mask. Format is same as the IP address.
Default Gateway
Default the Gateway IP Address. Format is same as the IP
address.
1
2
4
5
6
Preferred DNS Server
Define the DNS server IP address. Format is same as the IP
address.
Port
There are five ports in the camera providing different
services. To get those services separately, unique port
number must be assigned to each servers.
IPv6 Setting
Create the IPv6 address. If you click the Apply button after
checking the Enable check box, the system will be re-booted.
If you re-visit this screen after finishing reboot, IPv6 address
will be shown.
To use IPv6, network camera has to connect with the router for
IPv6.
Click ‘Apply’ to make above setting effective.
If the network type is dynamic, the IP address is changed in
below cases. Therefore, the IP address needs to be searched
again, and the camera needs to be reconnected in these
cases.
- When the camera power is on/off.
- After Firmware update, Default set and reboot.
7
3
8
1
2
3
4
8
6
5
7
30
