October 2015
34 GTH-1256 Part No. 57.0009.0662
Second Edition - First Printing
Operating Instructions
DPF Regeneration
(Deutz con
fi
guration)
Based on the blinking combination of the DPF
indicator lights, proceed as below:
12
7
1. When the Diesel Particulate Filter indicator
light, 7, starts blinking but the Engine Critical
Fault indicator light, 12, remain off, the
operator has to start the DPF regeneration
following these instructions:
i
Select a safe outdoor parking location:
•
firm level surface
•
clear of obstruction and traffic
•
clear of fiammable material
•
clear of explosive atmospheres
ii Set the parking brake.
iii Move the transmission control lever to
neutral.
iv Warm up the engine; the coolant
temperature must reach at least 75°C.
v Keep the engine on.
vi Activate the DPF regeneration pushing on
the DPF switch: indicator light 7 becomes
a solid light and the enigne revs up to
1,500/1,600 rpm.
vii Keep clear of the exaust muffler area.
viii Don’t leave the machine unattended.
ix Signpost the area.
When the indicator light is OFF, the travelling
speed is beyond the admissible speed range and,
by pressing the switch, gear won’t be shifted.
If the indicator light flashes, there are errors or
problems. Try to modulate the machine speed and
check if the light comes on with a solid light.
The speed engagement is signalled by the
dedicated indicator lights, according to the
engaged speed.
While traveling less than 3 mph on slopes the shift
on the fly system may not allow 2nd to 1st gear
transition.
Shift to 1st gear before ascending steep slopes.
Come to a complete stop using the service brake
before shifting from 2nd to 1st gear.
Axle Differential Lock
Use the axle differential lock switch to lock the
axle differential and gain added traction in certain
types of terrain such as sand, mud or snow.
Come to a complete stop before activating the
axle differential lock. Do not lock the axle when
the machine is moving.
Push the switch to activate the axle differential
lock. Release the switch to release the axle
differential lock.
Frame Sway Control
Before raising the boom, the machine must be
level.
1 Check the left to right level indicator. The left
to right level indicator should be 0 degrees
before raising the boom.
2 If the machine is not level, use the frame sway
control function to level the machine.
Only use the frame sway control function if the
boom angle indicator is at 0 degrees or less.
See Controller Movements section.
