16
Genie GS-2668 DC & GS-3268 DC
Part No. 52546
Operator's Manual
First Edition • Seventh Printing
FUNCTION TESTS
21 Push and hold a function enable/speed select
button. Activate the platform down function.
Result: The platform should lower. The descent
alarm should sound while the platform is
lowering.
Test the Steering
Note: When performing the steer and drive
function tests, stand in the platform facing the
steer end of the machine.
22 Press and hold the function enable switch.
23 Depress the thumb rocker switch on top of the
control handle in the direction identified by the
blue triangle on the control panel.
Result: The steer wheels should turn in the
direction that the blue triangle points on the
control panel.
24 Depress the thumb rocker switch in the
direction identified by the yellow triangle on
control panel.
Result: The steer wheels should turn in the
direction that the yellow triangle points on the
control panel.
Test Drive and Braking
25 Press and hold the function enable switch.
26 Slowly move the control handle in direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
27 Press and hold the function enable switch.
Test the Manual Lowering
11 Hold the function enable switch to either side
and activate the platform up function and raise
the platform approximately 2 feet / 60 cm.
12 Pull the manual lowering knob or push the
manual lowering button located next to the
ground controls.
Result: The platform should lower. The descent
alarm will not sound.
13 Turn the keyswitch to platform control.
At the Platform Controls
Test Emergency Stop
14 Push in the platform red Emergency Stop
button to the
OFF
position.
Result: No functions should operate.
15 Pull the red Emergency Stop button out to the
ON
position.
Result: The green power light should come on.
Test the Horn
16 Push the horn button.
Result: The horn should sound.
Test the Up/Down Functions and the Function
Enable Switches
17 Activate the platform up function.
Result: The platform should not raise.
18 Push and hold a function enable/speed select
button.
19 Activate the platform up function.
Result: The platform should raise.
20 Release the function enable button.
Result: The platform should stop raising.
