Genie GC-1530, Руководство по обслуживанию

Страница: 175 / 270

Section 4 • Repair Procedures January 2012
Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47 4 - 113
SCISSOR COMPONENTS
Upper Lift Cylinder
a relief valve (schematic item Q)
b lift cylinder
c connector fitting
d hydraulic hose
e check valve (schematic item DK)
Torque specification
Solenoid valve, 2 position 2 way N.C. 20 ft-lbs
(schematic item N) 27 Nm
Relief valve 20 ft-lbs
(schematic item Q) 27 Nm
Coil nut 5 ft-lbs
7 Nm
Pressure transducer (if equipped) 27 ft-lbs
(schematic item R) 37 Nm
Check valve 20 ft-lbs
(schematic item DK) 27 Nm
21 Remove the lifting device supporting the link
stack at the steer end of the machine.
22 Connect the battery pack to the machine.
23 Turn the key switch to the ground control
position.
24 Press and hold the ground control scroll up and
scroll down buttons.
25 Pull out the red Emergency Stop button to the
on position at the ground controls.
26 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
27 Raise the platform and return the safety arm to
the stowed position.
28 Fully lower the platform to the stowed position.
Note: Models with a pressure transducer, calibrate
the Platform Overload System. Refer to Repair
Procedure 9-10,
How to Calibrate the Platform
Overload System (if equipped).