Genie GC-1530, Руководство по обслуживанию

Страница: 110 / 270

January 2012 Section 4 • Repair Procedures
4 - 48 GS-30 • GS-32 • GS-46 • GS-47 Part No. 228901
16 Install the fasteners removed in 14 to the
number 1 inner arm pivot bracket and chassis.
Tip-over hazard. Failure to install
the fasteners securing the number
1 inner arm pivot bracket to the
chassis, could result in the
machine tipping over, causing
death or serious injury.
17 Connect the battery pack to the machine.
18 Turn the key switch to the ground control
position.
19 Press and hold the ground control scroll up and
scroll down buttons.
20 Pull out the red Emergency Stop button to the
on position at the ground controls.
21 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
22 Raise the platform and return the safety arm to
the stowed position.
23 Fully lower the platform to the stowed position.
24 Remove the platform. See 10-1, How to
Remove the Platform.
25 Support and secure the entry ladder to an
appropriate lifting device.
26 Remove the fasteners from the entry ladder and
remove the entry ladder from the machine.
Crushing hazard. The entry ladder
may become unbalanced and fall
if not properly supported and
secured to the lifting device.
27 Secure the ends of the scissor arms together at
the steer end of the machine with a strap or
other suitable device.
28 Secure the ends of the scissor arms together at
the non-steer end of the machine with a strap or
other suitable device.
29 Remove the retaining fasteners securing the
chassis mount bracket to the chassis at the
steer end of the machine.
30 Attach a lifting strap from an overhead crane to
the scissor arm assembly.
31 Raise the scissor arm assembly at the steer
end with the overhead crane until the chassis
mount bracket will clear the level sensor.
SCISSOR COMPONENTS