Genie GC-1530, Руководство по обслуживанию

Страница: 119 / 270

Section 4 • Repair Procedures January 2012
Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47 4 - 57
84 Remove the number 1 cable bridge from the
machine.
85 Use a soft metal drift to remove the number 1
center pivot pins (index #9).
Bodily injury hazard. The number
1 outer arm may become
unbalanced and fall if not properly
supported when the pin is
removed.
86 Slide the number 1 outer arm (index #22) to the
non-steer end and remove it from the machine.
Bodily injury hazard. The number
1 outer arm may become
unbalanced and fall if not properly
supported when removed from the
machine.
87 Attach the strap from an overhead crane to the
number 1 inner arm (index #10). Do not lift it.
88 Remove the upper fasteners securing the
number 1 inner arm pivot bracket to the end of
the chassis. Loosen the lower fasteners.
89 Remove the number 1 inner arm (index #10)
from the machine.
Bodily injury hazard. The number
1 inner arm may become
unbalanced and fall if not properly
supported when removed from the
machine.
Component damage hazard. Be
sure not to damage the limit switch
or level sensor components when
the number 1 inner arm is
removed from the machine.
How to Replace the Scissor Arm
Wear Pads
Note: Machines equipped with a Platform Height
Sensor, begin at step 1. Machines without a
Platform Height Sensor, begin at step 24.
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
2 Raise the platform 7 to 8 feet / 2.1 to 2.4 m.
3 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
4 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
5 At the ground control, turn the key switch to the
off position and push in the red Emergency
Stop button to the off position.
6 Disconnect the battery pack from the machine.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
7 Remove the fasteners securing the platform
height sensor cover to the large platform height
sensor bracket.
8 Remove the platform height sensor cover.
SCISSOR COMPONENTS