Genie Chainlift 2020, Руководство по эксплуатации и обслуживанию, Страница: 9 / 20

For Help, call 1-800-35-GENIE or visit www.geniecompany.com
9
Coarse Setting of Limit Switches
A Setting Close Limit Switch ( Figure 9 ):
• Check that Magnetic Carriage Assembly is disengaged.
• With garage door fully closed, slide Close Limit Switch
until it is aligned with Carriage Assembly Magnet.
• Tighten Set Screw. Do Not over-tighten.
B Setting Open Limit Switch:
• Manually open garage door to full open position.
• Slide Open Limit Switch until it is aligned with Carriage
Assembly Magnet.
• Tighten Set Screw. Do not over-tighten.
• Re-engage Magnetic Carriage Assembly.
Setting Force Controls and Final Adjustment of
Limit Switches
A CLOSE ADJUSTMENT
•
On front panel of Power Head find adjusting screw
marked “CLOSE” (
Figure 9 ).
• Gently turn screw counterclockwise until it stops.
–
Very little force is required to turn adjusting screw.
• Press Wall Console to close garage door.
–
Observe if door stops at “CLOSE” limit switch.
If door is fully closed—adjustment is finished.
Go to “OPEN” Adjustment.
– If door stops but is not fully closed,
a.
Measure distance between bottom of door
and floor.
b. Move “CLOSE” Limit Switch that same distance
toward door.
– If door stops and/or reverses before reaching the
“CLOSE” Limit Switch
a.
Slightly increase CLOSE Force setting (clockwise).
– If door reverses after contacting floor, move Limit
Switch toward Power Head.
– If door fails to move, check Safe-T-Beam® System. See
Troubleshooting Section, pages 15 and 16.
Open adjustment next page.
WARNING
• The garage door opens rapidly, and can cause serious
injury or death.
• Keep the path clear.
• Position the ladder to the side of the Power Head so it is
clear of all moving parts of the Opener and the door.
• Set the door Opener to use the minimum force needed
to open the door.
NOTE
• Little effort is required to turn the Force
Adjusting Knobs.
• If the door stops moving while opening or
closing, adjust the Open Force or Close Force
Controls
slightly clockwise (to slightly
increase the force) and retry the step.
• The Open Force and Close Force Controls are to
be set to the
minimum force necessary to
ensure the door smoothly opens and
closes completely.
• Ensure the Carriage Assembly is engaged and is
between the two Limit Switches before
operating the Opener.
Figure 9 Making Force Adjustments
(Located Lower Right Corner).
C
H
S
ET
L
IMIT
S
WITCHES AND
F
ORCE
C
ONTROLS
A
DJUSTMENT
1:
A
DJUSTMENTS
LOCATED
UNDER
LIGHT
COVER
OPEN
FORCE
CLOSE
FORCE