Genie Industries Z-30/20, Руководство по обслуживанию

Страница: 120 / 150

7 - 10 Genie Z-30/20 Part No. 43063
Service Manual - Third Edition Section 7 - Repair Procedures
2 Remove the seven mounting bolts from the
platform rotator cover, then remove the cover.
3 Visually inspect the inside of the platform
rotator for the following items:
· Excessive wear
· Broken or damaged parts
· Rust or corrosion
· Binding
Replace any worn or damaged
parts.
If any parts are lightly rusted or
corroded, remove them and clean
rust or corrosion off with a wire
brush. If parts are heavily rusted
or corroded, replace them.
4 Loosen the locknut in the counterclockwise
direction just enough to allow the handle to
rotate.
5 Thoroughly grease the entire mechanical
platform rotator assembly.
6 Tighten the locknut and check for platform
tighteness by grabbing the rails of the platform
and trying to twist it side to side. Tighten the
locknut until it is difficult to twist the platform.
7 Operate the platform rotator and check for
smooth operation.
PLATFORM COMPONENTS